This problem has not been reported before. Please send in a minimal example scenario (either to the mailing list or attached as a zip on a new github issue).
regards, Jakob Am Fr., 20. Nov. 2020 um 19:25 Uhr schrieb . Abdullah <[email protected]>: > Hi, > > I have a network where only 2 cars are travelling (for testing purpose). > If I let the simulation run to completion none of cars stand too long in > front of an intersection and no teleportation occurs. But when I save a > state in the middle of the simulation and start the simulation again from > the saved state, the cars do travel to the nearest intersection but then > they get stuck there and get teleported to the next edge. They do not move > even when there is a green phase or there are no vehicles in the opposite > lanes. Has anybody faced this kind of problem before and know why this is > happening? > > For saving state I am using: > traci.simulation.saveState('saved_simulation') > traci.close() > > And for loading state: > traci.start([checkBinary('sumo-gui'), "-c", "config.sumocfg", > "--load-state", 'saved_simulation']) > > I am using SUMO 1.7.0. Let me know if you want me to give you a small code > for sanity check. > > -- > Thank you. > Abdullah > _______________________________________________ > sumo-user mailing list > [email protected] > To unsubscribe from this list, visit > https://www.eclipse.org/mailman/listinfo/sumo-user >
_______________________________________________ sumo-user mailing list [email protected] To unsubscribe from this list, visit https://www.eclipse.org/mailman/listinfo/sumo-user
