Hi, thank you for the answer. Looking at traci.simulation.loadState, it only takes a filename, is there a way to specify these options (["--step-length", "0.5", '--save-state.rng', "--step-method.ballistic", "--no-step-log", "--no-warnings"], port=port) like I can for traci.start
Also, when I measure the time across traci.simulation.getDeltaT(), it takes from 0 to 0.001 seconds rather than 0.5 seconds. So, I am a bit confused about how long it actually takes for sumo to perform one simulation step? On Sun, Jan 31, 2021 at 5:44 AM Jakob Erdmann <[email protected]> wrote: > Hello, > the delay most likely comes from loading the network and setting up all > the necessary simulation objects in memory. > If you need to start a simulation repeatedly, you can avoid the overhead > of network loading by calling traci.simulation.saveState and > traci.simulation.loadState > > regards, > Jakob > > Am Sa., 30. Jan. 2021 um 23:15 Uhr schrieb . Abdullah <[email protected]>: > >> Hi all, >> >> I have two codes below. In traci_demo_v1, I have a loop that just starts >> and closes a simulation and prints the time taken to do so. In windows, it >> takes around 0.5 secs but when I check my task manager (Memory Usage.PNG >> file attached below) I see only some memory use of 35MB and no disk usage. >> So I was wondering why it takes so long to start or load a state (without >> gui)? Is there any way to reduce this time? Also, in traci_demo_v2 I have a >> simulation that runs for sometime with step-length 0.5. But when I measure >> the time across traci.simulation.getDeltaT(), it takes from 0 to 0.001 >> seconds rather than 0.5 seconds. So, I am a bit confused about how long it >> actually takes for sumo to perform one simulation step? >> >> I am using SUMO v1.7. >> >> >> -- >> Thank you. >> Abdullah >> _______________________________________________ >> sumo-user mailing list >> [email protected] >> To unsubscribe from this list, visit >> https://www.eclipse.org/mailman/listinfo/sumo-user >> > _______________________________________________ > sumo-user mailing list > [email protected] > To unsubscribe from this list, visit > https://www.eclipse.org/mailman/listinfo/sumo-user > -- Thank you. Abdullah
_______________________________________________ sumo-user mailing list [email protected] To unsubscribe from this list, visit https://www.eclipse.org/mailman/listinfo/sumo-user
