Hello, I modeled a three-lane freeway network with an off-ramp.Before 200 meter of off-ramp,I designed a parallel deceleration lane for outflow vehicles. If I look into netedit connection mode, connection between the lanes is as shown below. In this case,there is no vehicle that goes through the left-most lane to the right-most lane(deceleration lane) for outflow. [image: image.png] If I change it with using Ctrl+Shift+Left Click to pink (Target(pass)) is like as below figure,some vehicles goes through left-most lane to deceleration lane for outflow but in this case,I obtained collision warning as like figure below. [image: image.png] [image: image.png] How do I solve this problem? Thank you for helping,regards.
_______________________________________________ sumo-user mailing list [email protected] To unsubscribe from this list, visit https://www.eclipse.org/mailman/listinfo/sumo-user
