Hi Community,
I am writing this email to ask about how would the step-length value in the
sumocfg file would influence the simulation result. I tried two values as below:
Case 1:
<time>
<step-length value="0.1"/>
</time>
Case 2:
<time>
<step-length value="1"/>
</time>
All other settings are the same. I run simulations using a fixed-time traffic
signal controller at an isolated intersection. However, the results under the
two cases are significantly different: the average total travel loss of
vehicles for case 1 is around 40s but for case 2 is around 80s. From GUI,
congestion can be observed under Case 2 but not for Case 1. May I ask you about
possible reasons for that? Thank you.
Have a nice day.
Best,
Wangzhi
_______________________________________________
sumo-user mailing list
[email protected]
To unsubscribe from this list, visit
https://www.eclipse.org/mailman/listinfo/sumo-user
