Hi All,
I figured it out that I can use the validation.xml as an additional file while
I run the simulation to generate validation_dets.xml. However, most of the
sensors have 0 counts, which is very different from the real information
(failed validation). When I use dfrouter, I still got a lot of warnings like
"Quitting checking for being a source for detector ... due to seen edge limit."
and "Could not close route for...". Did these warning cause the problems? And
how should I get rid of these warnings?
Thank you very much.
Best,
Tran
On Monday, January 4, 2016 10:54 PM, Nguyen Nguyen
<[email protected]> wrote:
Hello All,
I performed dfrouter to import sensor information and want to validate the
simulation. I put detectors at those locations and retrieve the vehicle counts
and speed for validation but most of the sensors read 0. Could I do this for
validation? Is there anything wrong with this?
Moreover, I also saw that we can perform validation by --validation-output
validation.xml, but when I ran the simulation, I got an xml file with some
information like:
<e1Detector id="validation_10113" lane="-121939397#30_0" pos="104.24" freq="60"
friendlyPos="1" file="validation_dets.xml"/>
There is no validation_dets.xml created, and I do not how to use this file for
validation.
Could you please explain more clearly how I should validate my simulation using
dfrouter..
Thank you very much.
Best regards,
Tran
------------------------------------------------------------------------------
_______________________________________________
sumo-user mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/sumo-user
