Otto,
Thanks for the reply. This and other mails made me realise it was not
the bridge but something wrong in my setup. I have since gone back and
fixed the problems which turned to be to do with the interconnect
Rgds
Paul
[EMAIL PROTECTED] wrote:
"Paul Matthews" <[EMAIL PROTECTED]> wrote:
I am using some wireless bridges
(Pheenet WAP 11) so that the ray thinks it is connected to a normal
wired hub. So far I am only seeing the IP address on boot up. I
guess the tftp boot forwarding is the issue but on the bridges in
question there appears to be no option to enable bootp.
If these are bridges then they should just blindly forward all
frames. Bridges don't know or care about BOOTP or TFTP or anything
else above the link layer. If the Sun Ray boots when it's plugged
into the wire at the far (server) end of the wireless link then it
should boot when it's plugged into the bridge. (I'm assuming that
the Sun Ray traffic isn't being blocked by some sort of access
control or filtering.)
What does the Sun Ray show in the bottom right corner of its
on-screen startup icon, and what does a 'snoop' capture of the
traffic on the server's interface to this subnet show?
OttoM.
__
ottomeister
Disclaimer: These are my opinions. I do not speak for my employer.
_______________________________________________
SunRay-Users mailing list
[email protected]
http://www.filibeto.org/mailman/listinfo/sunray-users
