Aaron Browne wrote:
I hadn't thought about this before but I deployed a couple of units at
work today and the staff wanted to know where the power switch was.
This was a good question as we have a green policy which basically
means we turn everything off overnight if not required. I know the
SunRay 2 and 2FS units have very low power requirements but every bit
counts.
Has anyone else had this question come up and/or a solution?
Unfortunately in most cases these units are being plugged into power
sockets with no switches so having a switch on the unit would be
handy.
As far as a switch in the unit, we have often considered it but decided
against it primarily for RAS reasons - it's one more thing to break, but
also for cost reasons.
Within Sun, every office has a motion sensor to turn off lights and
an outlet when nobody is there. The Sun Rays plug into that power
outlet. Within our lab, where we have many Sun Rays, we use power
strips with switches. In the unlikely event that a switch fails, it's a lot
cheaper to replace the power strip than a Sun Ray.
-Bob
Opinions expressed are mine, not my employers.
_______________________________________________
SunRay-Users mailing list
[email protected]
http://node1.filibeto.org/mailman/listinfo/sunray-users
