[SunRay-Users] 1680 x 1050 digital Treff, Douglas Douglas.Treff at EssexCorp.com <mailto:sunray-users%40filibeto.org?Subject=%5BSunRay-Users%5D%201680%20 x%201050%20digital&In-Reply-To=> Thu May 1 16:19:54 EEST 2008 * Previous message: [SunRay-Users] Debugging GDM/Xnewt <009464.html> * Next message: [SunRay-Users] New SRCS patch update for SRSS 3.0 <009472.html> Messages sorted by: [ date ] <date.html> [ thread ] <thread.html> [ subject ] <subject.html> [ author ] <author.html>
Doug, Regarding your post: make sure you get the CID [canonical ID] right in the utresadm command. On my SRS, it takes the form IEEE802.MAC_ADDR You'll need to do a utrestart [we did a "cold"; not sure if a "warm" would suffice]. Also, the settings get propagated via the data store to other SRSs so even if DTUs were getting redirected with utswitch, I would think that would be taken care of automatically. Scott All, New to the list, apologies if this has been covered before, but here goes: Our environment: SRSS 4.0 running on RHEL 4u3 Sun Ray 2FS DTU's Dell 2007WFP monitors Cybex Switchview SC4UAD KVM's I have some Dell widescreen monitors that we recently purchased. Their "optimal" resolution is 1680x1050 at 60 hz. When we connect them to the SunRay 2FS via DVI, they default to 1280x1024 and the image is stretched to fill the added width. If we use the Sun supplied adapters to connect them via VGA, they default to the desired 1680 x 1050. Looking at the modes listed when I run utresdef, it does not list a built-in timing for 1680 x 1050 60 Hz (digital). We intend to connect them to a KVM switch that has DVI ports, but we really need them to also run at the desired 1680 x 1050 resulotion. >From some of my reading on the topic, I SHOULD be able to issue the following command: /opt/SUNWut/sbin/utresadm -a -c <DTU ID> -t default 1680x1050 at 60 <http://www.filibeto.org/mailman/listinfo/sunray-users> This should force the DTU to go into that mode. The last time I started playing with these settings I got myself all messed up. I am looking for some guidance before I play again. Will this work in this configuration even if the mode is not listed as built-in? Nex question - If some of my sessions are redirected elsewhere using utswitch to another SunRay server, do I also need to set this on the destination SRSS server? Thanks, _________________________________ Doug Treff Essex Corporation, a Northrop Grumman company EFIT Team 301-377-7132
_______________________________________________ SunRay-Users mailing list [email protected] http://www.filibeto.org/mailman/listinfo/sunray-users
