That should do the trick. Thanks OttoM.
________________________________ From: ottomeister <[email protected]> To: SunRay-Users mailing list <[email protected]> Sent: Wed, July 7, 2010 4:31:09 PM Subject: Re: [SunRay-Users] Changing resolution on 2FS using VDI/UTTSC On Wed, Jul 7, 2010 at 11:03 AM, JKG <[email protected]> wrote: > I have a 2FS with two Dell widescreen(16:10,1680×1050) connected and I've > been asked to lower the resolution so that the users can see things better. > > I've tried using utresadm to set a default resolution for the DTU for all > tokens. The problem is that the frame buffer dimension are not correct that > the monitors have a black bar at the bottom. I've tried using utresexec to > clear out the resolutions but it didn't seem to help. I've only had this > issue with the 2FS, the 2 and 270 work fine using utresadm. > > I'm using utresadm -a -c IEEE802.<mac> -t default 1440x...@60 That will force the timing on the 2FS's first monitor output but it won't affect its second output, which will continue to run at the monitor's preferred resolution. To force the second output to that same timing do: utresadm -a -c IEEE802.<mac> -t default -v 2 1440x...@60 OttoM. __ Disclaimer: I am employed by Oracle. The statements and opinions expressed here are my own and do not necessarily represent those of Oracle Corporation. _______________________________________________ SunRay-Users mailing list [email protected] http://www.filibeto.org/mailman/listinfo/sunray-users
_______________________________________________ SunRay-Users mailing list [email protected] http://www.filibeto.org/mailman/listinfo/sunray-users
