P9 firmware was first made available in the Sun Ray Core Services Patch
-02 patch. We are now at 03. Load that patch and do the appropriate
utfwadm commands for the type of interconnect you have.
http://wikis.sun.com/display/SRS/Home#tab:Patches
Seth Galitzer wrote:
I'm finally ready to deploy my new 3+ DTUs, adding 16 to an existing lab
of 24 2FS DTUs. They will be sharing the same SRSS host, which I just
upgraded to SRSS 4.2 and SRWC 2.2 (clean install, actually). Upon
booting the DTU, it returns a 4G error, "FW load: bad read". The DTU
finishes booting, and is able to run its kiosk apps.
From what I've found, this error means the DTU is unable to load the
firmware provided by the server. I know that the 2FS requires a P8
firmware and the 3+ requires a P9 firmware. Is there something special
I need to do to enable the appropriate firmware for each set of DTUs, or
will the server be able to figure out which to distribute? Also, do I
need to do anything special to enable firmware distribution for the new
DTUs?
I've been looking in the list archives and haven't found an answer yet,
nor have I found it in the manuals, though I'm sure I could have just
missed it. I'm running the above-mentioned versions of the software on
a freshly installed Solaris 10 10/09 U8, for x86.
Any help is greatly appreciated.
Thanks.
Seth
_______________________________________________
SunRay-Users mailing list
[email protected]
http://www.filibeto.org/mailman/listinfo/sunray-users
