Adding "poweroff=0" to your .parms file will prevent it from powering down.
poweroff= Sets how much time a Sun Ray 3 Series Client will be idle before it turns off. The default power off time is 30 minutes. Setting poweroff=0 disables the power off feature. When the power off feature is enabled, the firmware enforces a minimum power off value of 10 minutes and a maximum power off value of 30 days. The value for the power off feature is in minutes. For example, poweroff=15 sets the idle power off timer to 15 minutes. -----Original Message----- From: [email protected] [mailto:[email protected]] On Behalf Of Adams, Clifford B Sent: Wednesday, September 21, 2011 4:24 PM To: SunRay-Users mailing list Subject: [SunRay-Users] Sun Ray 3FS shutdown issue All, We've just installed Sun Ray 3FSs and have noticed a problem with them powering down after not being in use for a while. Once the power button is pressed, it takes a minute or so for the system to become accessible again. This is not normally an issue unless when it comes to the end of the day and systems have to be checked to ensure that all users have logged off. Is there any way to prohibit this behavior or lessen the amount of time that it takes for the system to become active again? Clifford B. "Goose" Adams Jr. SBSS Systems Administrator Inverness: 719-572-8114 (P), Schriever AFB: 719-567-5556 (A) Cell: 719-351-4344 Fax: 719-572-8101 _______________________________________________ SunRay-Users mailing list [email protected] http://www.filibeto.org/mailman/listinfo/sunray-users _______________________________________________ SunRay-Users mailing list [email protected] http://www.filibeto.org/mailman/listinfo/sunray-users
