2011-12-12 10:32, P.S.M.Swamiji пишет:
On 12/09/11 12:35, Jim Klimov wrote:
Hello, all
I was wondering if it was possible to "blindly" (without a
working monitor) to change or reset-to-defaults a SunRay's
settings saved in flash while using the GUI mode?
Stop +C --> Enter --> Right Arrow --> Enter.
It will reset all the GUI config info.
Thanks, PSM.
I guess there is no way (currently) to have say two config
profiles in a DTU Flash, such as "current" and "fallback"?
Meaning, that the "fallback" config is known-good non-zero,
for example with VPN data required to get an SRSS session,
while "current" is a clone of the "fallback" which I fiddle
with and have a chance to break things?
Such reverting to last-known-good config is not available?
Thanks,
//Jim
Thanks
P.S.M.Swamiji
Note: These are my personal opinions, nothing to do with my employer
More detail:
My LCD monitor does not work in the low resolution that SR2
uses just after bootup. So if there is no connection to the
server for any reason, which would set DTU to an acceptable
resolution, I can't see anything and at most can try blind
typing. This makes use of OSD menu kinda tricky ;)
I wanted to experiment with networking settings, but since
they are likely to leave my DTU not connected and "blind",
I wanted to have a back-out plan - such as resetting the
GUI settings to factory defaults, or preferably to the
last-known-good ones.
Is that possible? Or should I better memorize the OSD? ;)
Thanks,
//Jim
_______________________________________________
SunRay-Users mailing list
[email protected]
http://www.filibeto.org/mailman/listinfo/sunray-users
_______________________________________________
SunRay-Users mailing list
[email protected]
http://www.filibeto.org/mailman/listinfo/sunray-users
