Am 29.10.12 16:32, schrieb lists:
I have recently received and started using (or am trying to) a Sunray 3+.
We have two sunray servers at work one an old 4.x (primary) and one a
5.2 on my 2 FS I would just go to the config gui and enter the IP of
the 5.2 srs server. The problem I am having is that the 3+ has the
config gui disabled.
I have been trying to enable it with no success.
I have been trying things such as`# utfwadm -AV -e $CLIENT_MAC -G
none` but the 3+ does not want to play.
This will only work, if the Sun Ray finds and chooses that server as its
firmware server.
What mechanism do you use to provision the Sun Ray with initial parameters?
Please run
utquery <ip-of-sunray>
on the server to check what firmware server the Sun Ray has chosen.
Has any one any suggestion around getting the GUI enabled on the 3+
I did try to look for the newer firmware so i could add it to srs 5.2
but finding anything on the Oracle support site when you do not know
exactly what you are looking for is shall we say _tricky_ .
If you can get the Sun Ray to load specific firmware (i.e. from a
firmware server you control), then you can also get it to enable the GUI.
HTH
- Jörg
--
Jörg Barfurth http://blogs.oracle.com/joergb
Disclaimer: I am employed by Oracle. The statements and opinions
expressed here are my own and do not necessarily represent those
of Oracle Corporation.
_______________________________________________
SunRay-Users mailing list
[email protected]
http://www.filibeto.org/mailman/listinfo/sunray-users
