>Chrisso <[EMAIL PROTECTED]> > > Date: Sun, 14 Apr 2002 22:11:46 +0200 > > > > > Ok, i bought an old Philips 14C (7CM5209) monitor today for > bringing life > back into my old trusty PPC 7200. I use the Twin Turbo 4MB > which came with > my S900. Problem is: I can�t get any resolution higher than > 800x600, 60hz, > the only other is 640x480, 67hz. > The manual says the monitor will support res. up to 1024x768, > 87 hz, but > this and all the others shown in the control panel are > completely out of > sync. > > Chrisso
Ok a couple of things to try. You could try using a simple Mac to VGA adapter which would let you use the Mac port on the Twin Turbo card. This works in some cases. The other thing to try is: Are you using control strip? If so when clicking on the monitor panel hold down the control key this will give you all available resolutions.If not using this go to monitors control panel and switch from "recommended resolutions" to "all resolutions". You will need to be careful when using a VGA monitor not to pick a resolution too high for your monitor or you could fry it.A Mac monitor won't let you pick one that would harm it. I hope this works for you. Will S -- SuperMacs is sponsored by <http://lowendmac.com/> and... Small Dog Electronics http://www.smalldog.com | Refurbished Drives | Service & Replacement Parts [EMAIL PROTECTED] | & CDRWs on Sale! | SPECIAL SM LIST PRICES - 24x Bootable SCSI CDROM $39.99, Umax Processors $19.99 PowerSupplies from C500/C600 $49.99 J700/S900 $79.99 <mailto:[EMAIL PROTECTED]> Support Low End Mac <http://lowendmac.com/lists/support.html> SuperMacs list info: <http://lowendmac.com/supermacs/list.shtml> Send list messages to: <mailto:[EMAIL PROTECTED]> To unsubscribe, email: <mailto:[EMAIL PROTECTED]> For digest mode, email: <mailto:[EMAIL PROTECTED]> Subscription questions: <mailto:[EMAIL PROTECTED]> Archive: <http://www.mail-archive.com/supermacs%40mail.maclaunch.com/> Using a Mac? Free email & more at Applelinks! http://www.applelinks.com
