Hi all, I'm pulling what's left of my hair out.
I have a Kyocera FS-600 laser printer, connected to my Umax with a Powerprint USB to parallel converter. OK so far, but the printer prints a sheet with some printer commands before starting on the job I've set it to do. It's obvious that the printer isn't responding to these codes, although I'm using the correct driver (Laserjet 5). I've tried other Laserjet drivers and contacted Powerprint, but there doesn't seem to be an answer. Has anyone else seen this and can perhaps give me an answer please? Cheers -- Regards, Derryck -- SuperMacs is sponsored by <http://lowendmac.com/> and... Small Dog Electronics http://www.smalldog.com | Refurbished Drives | Service & Replacement Parts [EMAIL PROTECTED] | & CDRWs on Sale! | Support Low End Mac <http://lowendmac.com/lists/support.html> SuperMacs list info: <http://lowendmac.com/supermacs/list.shtml> --> AOL users, remove "mailto:"; Send list messages to: <mailto:[EMAIL PROTECTED]> To unsubscribe, email: <mailto:[EMAIL PROTECTED]> For digest mode, email: <mailto:[EMAIL PROTECTED]> Subscription questions: <mailto:[EMAIL PROTECTED]> Archive: <http://www.mail-archive.com/supermacs%40mail.maclaunch.com/> --------------------------------------------------------------- >The Think Different Store http://www.ThinkDifferentStore.com ---------------------------------------------------------------
