I tried to move the Umax U/W/ethernet card from one box to another, and it stops the boot process. I take it out and the machine boots up just fine. It's the card with both a 68-pin female and an Ethernet port.
Is there software required? Does it only work in certain PCI slots?
Any help will be appreciated. Thanks.
requires drivers for enet - scsi drivers in firmware on card
fully functional only in the first pci slot (the extended one) scsi functions in any slot
software available at:
ftp://ftp.umax.com/supermac/e100
I just recently swapped the wife's s900 from the 10bt enet to the e100 for some 100bt transfers on the lan, and experienced the same lockup under 9.1. cmd-opt-p-r at startup to zap the pram seemed to resolve it. I did learn that I had to have the Apple Enet extension enabled to be able to choose the e100 slot as a connection for appletalk and tcp/ip. Appletalk stores some settings in nvram, and I think that is what was causing the conflicts.
tom
-- SuperMacs is sponsored by <http://lowendmac.com/> and...
Small Dog Electronics http://www.smalldog.com | Refurbished Drives | Service & Replacement Parts [EMAIL PROTECTED] | & CDRWs on Sale! |
Support Low End Mac <http://lowendmac.com/lists/support.html>
SuperMacs list info: <http://lowendmac.com/supermacs/list.shtml> --> AOL users, remove "mailto:"; Send list messages to: <mailto:[EMAIL PROTECTED]> To unsubscribe, email: <mailto:[EMAIL PROTECTED]> For digest mode, email: <mailto:[EMAIL PROTECTED]> Subscription questions: <mailto:[EMAIL PROTECTED]> Archive: <http://www.mail-archive.com/supermacs%40mail.maclaunch.com/>
---------------------------------------------------------------
The Think Different Store
http://www.ThinkDifferentStore.com ---------------------------------------------------------------
