Hi, I have two rules on the WAN interface to try to get it through....
The first rule allows all traffic to pass to the mailserver IP proto *, Source *, Port *, Destination $MAILSERVERIP, Port * Gateway * I wrote that one after I wrote this one... Proto *, Source *, Port *, Destination $MAILSERVERIP, Port 25, Gateway * Those rules are 1 and 2 on WAN. I will do some more investigation... funny thing is I could not find anything in the firewall logs on denying port 25. Thanks, ----- "Chris Buechler" <[email protected]> wrote: > On Tue, Dec 29, 2009 at 2:26 PM, Seth Mos <[email protected]> wrote: > > Op 29 dec 2009, om 20:05 heeft Mark Street het volgende geschreven: > > > > Hi, > > > > I ran nmap from remote servers and sure enough port 25 is not > accessible. I > > set rules on the WAN to allow SMTP to pass through to the external > address > > on OPT1 and still no pass. Running netstat on the mail host shows > port 25 > > to be "filtered". > > > > Have you also added rules for allowing return traffic? Because that > will be > > originating from the opt1 to the internet. > > Not entirely sure on bridges as I don't use them a lot (once > actually). But > > iirc you need to add firewall rules on the opt1 interface as well. > > Only for traffic initiated outbound, bridges act the same as routed > or > NATed interfaces in that regard. Just need a rule on WAN to allow > traffic in. > > --------------------------------------------------------------------- > To unsubscribe, e-mail: [email protected] > For additional commands, e-mail: [email protected] > > Commercial support available - https://portal.pfsense.org -- Mark Street, D.C., RHCE Chief Technology Officer Alliance Medical Center (707) 433-5494 --------------------------------------------------------------------- To unsubscribe, e-mail: [email protected] For additional commands, e-mail: [email protected] Commercial support available - https://portal.pfsense.org
