----- Original Message -----
From: "Chris Buechler" <[email protected]>
To: <[email protected]>
Sent: Saturday, January 09, 2010 12:24 AM
Subject: Re: [pfSense Support] 1:1 NAT - bind actual external IP to an
optional interface?
On Fri, Jan 8, 2010 at 5:27 PM, Karl Fife <[email protected]> wrote:
That's preciesely right.
Inside: LAN, Outside: WAN.
Is that the right setting for the shaper in this bridged configuration?
(And again OPT2 is bridged to WAN, OPT1 is currently idle, Soekris 5501)
Because of the limitations of the shaper in 1.2.x you'll end up with
unusual results for anything other than the defined inside and outside
interfaces. Pre-2.0 there isn't a way to effectively shape in that
scenario.
I see. I was hopeful about the 1.2.3 shaper when I noticed "not compatible
with bridging" message (present in 1.2.2) had been removed. Is the 2.0 beta
available for embedded?
Thanks
-Karl
---------------------------------------------------------------------
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]
Commercial support available - https://portal.pfsense.org
