On 10-12-05 06:22 PM, Alex Threlfall wrote:
Hi All,
Doing some testing here, and this might not be the best place to ask
but thought I'd start off here!
I'm running a pair of pfSense 2.0 Beta 4 LiveCD's back to back with
a pair of WAN connections between them via x-over cat5's. Fairly normal
hardware, HP DL360 G3's with a Dual Port Intel FXP Card (onboard BGE is lan)
I'm trying to prove that I can run two IPSec VPN's between the
boxes, to provide some fault tolerance, however I can only get the VPN's to
link up on the WAN interface, despite specifying on both boxes that the
second VPN should be on OPT1 (or WAN1 which I've named it).
Can anyone shed any light on this behaviour, I have firewall rules
allowing all traffic on both interfaces and the IPSec Interface, private
networks turned off etc.
Cheers!
If you are trying to connect the same two subnets by two different IPSec
tunnels then I am afraid it is impossible. I can't see the way they can
run simultaneously regardless pfSense version. It is probably possible
in 2.0 bring back up IPSec if primary fails - I am not sure about that
as I do not have much
experience with 2.0.
Evgeny.
---------------------------------------------------------------------
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]
Commercial support available - https://portal.pfsense.org
