Oleg, thanks for the update, I tried this with two 359 boards but it has
no (immediate) effect - I get the scrambled/black image combination as
always.
I suspect that the SDRAM chip has gone: Switching the camera via the
camera control interface to a single channel (1) shows a live image. As
soon as I switch to channel 2, I get a few black pixels at the top with
one of the boards, the other one shows an image portion (~1/4 frame) of
the other camera but the transfer freezes immediately after that.
Do you have a replacement board available? I wrote to sales@ but got no
answer. Please contact me directly, thanks!
Simon
Am 24.06.20 um 01:42 schrieb Oleg:
The attached file worked for me. Set phase value to 44. See line 364:
...
echo "Sensor was successfully initialized at ".date("F j,
Y, g:i a")." from $configPath page $page\n";
/// Currently - only for eyesis
sync2master();
*elphel_set_P_value(ELPHEL_MULTI_PHASE_SDRAM, 44,
elphel_get_frame());*
}
...
On Tue, Jun 23, 2020 at 10:20 AM Simon Vogl <off...@voxel.at
<mailto:off...@voxel.at>> wrote:
Hm, indirectly yes - I cross-tested with another 353 cam heads
(with its own fpc) and different mux boards. The mux boards in
question consistently fail.
Will start testing your proposals tomorrow morning!
Meanwhile I've asked your sales about replacement boards as we
urgently need a solution
Thanks very much for your quick responses - really appreciated!
Simon
Am 23.06.20 um 18:03 schrieb Oleg:
Have you tried swapping the cable between the mux board and the
system board?
On Tue, Jun 23, 2020 at 10:01 AM Oleg
<support-list@support.elphel.com
<mailto:support-list@support.elphel.com>> wrote:
Hi,
MULTI_PHASE_SDRAM is indeed not stored in any firmware.
Instead it's remeasured every boot by the driver
(drivers/elphel/multisensor.c)--
[...]
Best regards,
Oleg Dzhimiev
Electronics Engineer
phone: +1 801 783 5555 x124
Elphel, Inc.
--
VoXel Interaction Design |www.voxel.at <http://www.voxel.at>
DI Dr.techn. Simon Vogl |si...@voxel.at <mailto:si...@voxel.at>
Tomaschekweg 46 | +43 650 2323 555
A-4040 Linz - Austria |
Office address: Industriezeile 35, 4020 Linz (2nd floor)
_______________________________________________
Support-list mailing list
Support-list@support.elphel.com
<mailto:Support-list@support.elphel.com>
http://support.elphel.com/mailman/listinfo/support-list_support.elphel.com
--
Best regards,
Oleg Dzhimiev
Electronics Engineer
phone: +1 801 783 5555 x124
Elphel, Inc.
--
VoXel Interaction Design | www.voxel.at
DI Dr.techn. Simon Vogl | si...@voxel.at
Tomaschekweg 46 | +43 650 2323 555
A-4040 Linz - Austria |
Office address: Industriezeile 35, 4020 Linz (2nd floor)
_______________________________________________
Support-list mailing list
Support-list@support.elphel.com
http://support.elphel.com/mailman/listinfo/support-list_support.elphel.com
