Hello Oleg! I updated the firmware from cvs to Camera release 8.0.6. With this update no phase adjustment is needed anymore, right? Both sensors work fork fine. Then I tried to follow your steps below.
1. switched to broadcast channel 7 on the http://192.168.0.9/359/10359_controls.html page 2. put the sensors in triggered mode as described by Andrey earlier 3. switched to "Alternation mode". 4. tried to record single frames in jpeg mode with camogm The result was that the frames were recorded from sensor 1 only. Should the alternating recording be possible with the "Alternation mode" button? Because currently I can't execute the "Alternation mode with buffering" button because I'm missing the http://192.168.0.9/359/10359_controls.html page. During the update I encountered another problem with the axis cris kernel. There was a problem with a "ext2-non-atomic" setting. I solved it by copying the kernel from the release. What is the preferred development setup? Best wishes, Andreas Bean Oleg Dzhimiev schrieb: > Hi Andreas, > > > During the last days I have mounted the 10359 board inside the camera > below the 10353 board. Two sensor boards are connected via a 6 > inch flex > cable. With your description I was able to switch the board to > triggered > mode and I was able to test the first sensor. Additionally with the > phase adjust page I was able to remove wrong pixels which were > caused by > the longer flex cable. So the first sensor board is working fine. > I was > not able to switch to the second one, simply because I don't know > how to > do that. > > > You can switch to the other channel in two ways: > 1. http://192.168.0.9/359/reg_write.php?adr=0x835&data=2 > <http://192.168.0.9/359/reg_write.php?adr=0x835&data=2> - that will be > the second channel (J3) > http://192.168.0.9/359/reg_write.php?adr=0x835&data=4 > <http://192.168.0.9/359/reg_write.php?adr=0x835&data=2> - 3rd channel > (J4) - the most distant from the cable to 10353 > > 2. or if you have firmware >8.0.5.2 you can try > http://192.168.0.9/359/10359_controls.html - and there you can find a > field for switching a channel - 1,2 or 4, and you also can try to > autoadjust phases. > > What I want to do is to record single framers which are captured > simultaneously and then written separately to disk using the > camogm > utility at a resolution of 1280x1024 at 40fps. Can you give me a short > description what I will have to do to achieve that? > > > Alternating frames 1280x1...@20fps from each channel that in sum will > give 40fps? Here I need to make a small revision of my previous work > while you are adjusting phases I checked CVS - and there's at least > one script is missing. > Basically, what you'll need to do is: > 1. Switch to broadcast channel (0x7) to program both sensors to the > resolution you need. > 2. Put sensors to triggered mode > 3. Switch on the alternation mode with buffering on 10359. > 4. and then use camogm to record frames > > Oleg > ------------------------------------------------------------------------ > > _______________________________________________ > Support-list mailing list > [email protected] > http://support.elphel.com/mailman/listinfo/support-list_support.elphel.com >
<<attachment: office.vcf>>
_______________________________________________ Support-list mailing list [email protected] http://support.elphel.com/mailman/listinfo/support-list_support.elphel.com
