Andrey,
Thank you for the information. I will check the sensor parameters, I
thought the phases are adjustet automatically since it worked perfectly
out of the box for the sensors connected to J2 and J3.
I will check it.
Concerning the Eyesis-4pi, have you already recorded imagedata together
with imu data?
How much is the 450mm cable?
Andreas
Am 27.05.2011 18:40, schrieb Andrey Filippov:
Andreas,
It is wrong phase setting on the 10359 FPGA - phase determines when
the pixel data is latched, it is possible to adjust it using
autocampars.php->parsedit.php. The phases are adjusted for each of the
cable - 10353-10359 (you should not modify as other sensors work, that
is SENSOR_PHASE parameter), and there are 3 separate phase setting for
each of the J2, J3 and J4 connectors.
Additionally, we now have custom flex cable ( FPC , actually) that
while having the same ends to fit the existent FPC connectors, has
ground conductor between each signal line, better preserving signal
integrity. This cable is 450mm long, it is designed fro Eyesis-4pi,
but can be used in other applications too.
Andrey
On Thu, May 26, 2011 at 10:53 PM, Andreas Bean <[email protected]
<mailto:[email protected]>> wrote:
Andrey,
Currently we are testing a 3 sensor setup with a 359 board. Its
basically working, but the connected to J4 shows some sort of
problems. Green and purple pixels in high brightness regions.
We have 3 359RevA boards and 5 10338RevD here.
I also interchanged the 359 and 10338 boards - always the same
result: J2,J3 is working fine, J4 sensor is delevering bad pixels.
Important also:
We have connected the sensors with an 8" ffc cable
The firmware revision is 8.0.8.48
Do you think is a software or hardware problem?
Andreas
_______________________________________________
Support-list mailing list
[email protected]
<mailto:[email protected]>
http://support.elphel.com/mailman/listinfo/support-list_support.elphel.com
_______________________________________________
Support-list mailing list
[email protected]
http://support.elphel.com/mailman/listinfo/support-list_support.elphel.com
