Hi Oleg, Thanks for the response,
Do you have any planned dates for the next generation? Regards Aaron On 23 March 2012 17:39, Oleg <[email protected]> wrote: > Hi, Aaron > > > I have been looking at the open hardware 353 camera that you have on your >> website, and noticed that you state you use the AXIS ETRAX FS, now I’m sure >> you know it has been discontinued since 2010, do you have a replacement for >> this part? I assume any ARM based processor will do? > > > The next generation of the system board is in planned. It's on hold until > the other big project is finished. > > >> Does the code have anything specific to the ETRAX or can it be used on >> any Linux distribution? > > > Most of the C code is not ETRAX specific (cross compiler deals with that). > But there are parts for the boot where special instructions could be used > (haven't seen it myself) like direct memory access. > > Best regards, > Oleg Dzhimiev > Electronics Engineer > phone: +1 801 783 5555 x124 > Elphel, Inc. > > On 21 March 2012 12:45, Aaron Wilkes <[email protected]> wrote: > >> Hi, >> >> >> >> I have been looking at the open hardware 353 camera that you have on your >> website, and noticed that you state you use the AXIS ETRAX FS, now I’m sure >> you know it has been discontinued since 2010, do you have a replacement for >> this part? I assume any ARM based processor will do? Does the code have >> anything specific to the ETRAX or can it be used on any Linux distribution? >> >> >> >> Kind Regards >> >> >> >> Aaron >> >> _______________________________________________ >> Support-list mailing list >> [email protected] >> http://support.elphel.com/mailman/listinfo/support-list_support.elphel.com >> >>
_______________________________________________ Support-list mailing list [email protected] http://support.elphel.com/mailman/listinfo/support-list_support.elphel.com
