Hi, does any know how to unbrick the 353L camera? I had installed a non-working kernel into the camera. So it doesn't start any more. But I can't put a new working kernel into it. Using elphel_8.2.8
I am... * Toggling power 5 times until lights appear. * Run "netboot .... -cmd rw", I get a JUMP response. (Tried "-cmd update" too) * Wait 3 minutes(orange light is still on). * Camera does not respond to ping or send nfs requests to the server. * So I toggle power 5 times, run "-cmd boot", Doing a -cmd boot without toggling the power just get stuck at "Starting boot..." * Still no response. I've tried other nfs servers too, no response. The mnt/flash/etc/reflash.conf points to the correct ip address. But I can't ping the camera so it may not be getting up to that stage. I had used reflash.php via the web before and it was working, but not "netboot" Thank you. ./netboot -d eth0 -mac 000E04081B2C 192.168.0.119:/nfs/latest80 -ip 192.168.0.9 -cmd rw Using internal boot loader: INTERNAL_NW - Network boot (default). Using internal boot loader: INTERNAL2 - Level2 boot. Starting boot... Connected. Booting device with random id 1f2f3963. Device ID = 1f2f3963 This bootloader compiled by hankin Thu Sep 20 23:53:23 EST 2012. Checksum of bootloader is 0x00509700 Waiting for load info. Got load info. SET_REGISTER 0xb0014000 0x0004044a SET_REGISTER 0xb0014004 0x00380000 . . . SET_REGISTER 0xb001a040 0x00000000 SET_REGISTER 0xb001a048 0x00000000 SET_REGISTER 0xb001a050 0x00000000 SET_REGISTER 0xb001a058 0x00000000 PACKET_INFO 0xc0004000 0x01144008 JUMP Exiting with code 0
_______________________________________________ Support-list mailing list [email protected] http://support.elphel.com/mailman/listinfo/support-list_support.elphel.com
