This message was received to "support-list-boun...@support.elphel.com" instead of "support-list@support.elphel.com", so I'm forwarding it to the right one.
Andrey ============ Forwarded message ============ From : mailman-boun...@support.elphel.com To : <support-list-ow...@support.elphel.com> Date : Tue, 28 May 2013 04:45:44 -0700 Subject : Uncaught bounce notification ============ Forwarded message ============ The attached message was received as a bounce, but either the bounce format was not recognized, or no member addresses could be extracted from it. This mailing list has been configured to send all unrecognized bounce messages to the list administrator(s). For more information see: http://support.elphel.com/mailman/admin/support-list_support.elphel.com/bounce ========================= Forwarded message ========================= Subject: camera recording onto usb stick problem From: "Gergely Debreczeni" Date: Tue, 28 May 2013 11:45:44 +0000 To: "support-list-boun...@support.elphel.com" ------------------------- Contents ------------------------- Dear Support, I’m trying to record some movie to the USB stick plugged into the camera In the following way: a.) Set the camera to triggered mode through the camera control web interface and set the fps The web interface shows the FPS I’ve just set so seems to be OK, so far. b.) telnet to the camera c.) start a camera with: camogm /var/state/camogm_cmd d.) killall autoexposure; killall camogm; e.) echo “status; exif=1; format=mov; duration=60000; length=10000000000; prefix=test; start;” >/var/state/camogm_cmd However I have the following problems: 1.) The recording starts much later than I launch the command 2.) The recording stops after a couple of seconds and I’m not able to record long movies 3.) There is a message always appearing Camogm.c: line 1362 got broken frame (-1) before waiting for ready Ending recording Starting recording Started OK Note: I’m able to record arbitrary long movies with recording the rtsp stream of the camera with ‘mencoder’ on a remote computer. I.) What I would like is to be able to record long movies using command line instructions on the camers. How can I do that ? II.) Is it also possible to set/edit the various camera parameters from the command line ? Thanks a lot, Gergely ====================== End of Forwarded Mail ====================== _______________________________________________ Support-list mailing list Support-list@support.elphel.com http://support.elphel.com/mailman/listinfo/support-list_support.elphel.com
