We have no internal CF Card connected. Please Tell us how To Enable The SATA Port
PatricK Am 05.08.2013 um 22:53 schrieb support-list <support-list@support.elphel.com>: > Patric, > > The only way how SATA can be disabled is if you have internal HDD or CF > cards. internal CF is always IDE master, CF cards master/slave depends on the > physical position and SATA can be set to either master or slave - see > http://wiki.elphel.com/index.php?title=10369#Example_-_setting_SATA_to_be_IDE_slave_.28needed_if_bottom_CF_card_or_internal_HDD_is_installed.29 > > If you have both CF inserted, it is not always possible to disable one of > them to be able to connect SATA. Some CF cards ignore IDE reset signal and so > they can not be disabled. > > In the earlier versions of the firmware you had to reboot the camera (w/o > power cycling) if you need to change the I2C control port bits. Current > firmware initializes IDE driver in two steps, the second step is performed > (with the modprobe command) in the very end of the startup process, so the > required i2c configuration of the IDE devices can be performed before that. > > Andrey > > >> We found out that our camera was build from sebastian pichelhofer with parts >> of two cameras one with a internal IDE and one with an external HDD. He told >> us that he used the pcb from the camera with the internal IDE to build the >> camera. Maybe the SATA port is disabled is there any possibility to enable >> it. >> >> Patrick > _______________________________________________ Support-list mailing list Support-list@support.elphel.com http://support.elphel.com/mailman/listinfo/support-list_support.elphel.com
