Hi Jan,
> In the second case TRIG is still 0, because as soon as I set that it stops > responding. > That's what happens when you set up external triggering but the signals are not received for some reason. Another way to test your cable would be trying the following settings: Master Camera: > TRIG_PERIOD=38400000 > TRIG_OUT=0x800000 (send trigger signals to J15) > TRIG_CONDITION=0x200000 (trigger source - J15) > TRIG=0x4 1. The order of applying TRIG and TRIG_CONDITION doesn't matter. If trigger signal is not generated then the camera will stop responding after applying the last parameter of these two. 2. If the Master camera doesn't stop responding then the cable and the port are ok. 3. The Slave camera can have exactly the same settings - so, you can test it in the Master mode as well - which only depends on the end of the sync cable plugged in. What results are you getting? Best regards, Oleg Dzhimiev Electronics Engineer phone: +1 801 783 5555 x124 Elphel, Inc.
_______________________________________________ Support-list mailing list Support-list@support.elphel.com http://support.elphel.com/mailman/listinfo/support-list_support.elphel.com
