Hi, Andrey I made it with gps sync timestamp and started two processing to capture and save image data. I have set the same exposure time for all channels.
Best Regrad! Yicheng-Zhang Email: winston.zh...@blacksesame.com.cn Teil: 18516291005 Addr: 707 room, 7th floor, building 4th, No.1761, Zhangdong road, Pudong area 发件人: Elphel Support [mailto:support-list@support.elphel.com] 发送时间: 2018年8月21日 星期二 0:40 收件人: Winston Zhang <winston.zh...@blacksesame.com.cn> 主题: Re: [Elphel-support] stereo sync Hello Winston, How did you measure that value? The synchronization between channels with the same delay settings synchronizes starts of erase/readout cycles, so if the channels have different exposure settings, the centers of the exposure intervals will be offset. You may set the same exposure time for all channels or use short enough exposures (you have to do that in any case to prevent motion blur) so that offset will not influence the results. It is also possible to set individual channel delays. Andrey ---- On Thu, 16 Aug 2018 21:15:16 -0700 Winston Zhang <winston.zh...@blacksesame.com.cn<mailto:winston.zh...@blacksesame.com.cn>> wrote ---- [cid:image001.gif@01D4395E.2EC02380] Hi,Andrey I found the spacing interval between the left camera and right camera time stamp was 0.3ms, when I dealt with stereo sync. Is it normal? Best Regrad! Yicheng-Zhang Email: winston.zh...@blacksesame.com.cn<mailto:winston.zh...@blacksesame.com.cn> Teil: 18516291005 Addr: 707 room, 7th floor, building 4th, No.1761, Zhangdong road, Pudong area _______________________________________________ Support-list mailing list Support-list@support.elphel.com<mailto:Support-list@support.elphel.com> http://support.elphel.com/mailman/listinfo/support-list_support.elphel.com
_______________________________________________ Support-list mailing list Support-list@support.elphel.com http://support.elphel.com/mailman/listinfo/support-list_support.elphel.com