Dear Ali,
We developed the PCBs for CMV12000 for our customer who decided to cancel the
project. So we have the boards built, but we never assembled and tested them
and we haven't designed FPGA and firmware code. We may revive this project in
the future, but our current focus is on long-range 3D with visible and infrared
cameras, and for visible range we prefer rolling shutter, not the snapshot ones.
Andrey
---- On Tue, 27 Oct 2020 02:15:32 -0600 ali tamimi <tamimial...@gmail.com>
wrote ----
Dear All
I was browsing your website that saw a long list of sensors will be supported
in future . It is a remarkable achievement if all of various sensors are
supported in future.
As you mentioned the "103982" board for the sensor front end CMV12000 can be
connected to 10393. You put PCB files but don't explain about software
requirements. Is there any special driver for it; or need code change?
Another question, why do you not mention CMV12000 in the main list of supported
sensors?
I provide CMV8000 and want to drive it with your product "10393" and need your
help to do that. It makes me proud to be part of your community and collaborate
in your project.
best regards
_______________________________________________
Support-list mailing list
mailto:Support-list@support.elphel.com
http://support.elphel.com/mailman/listinfo/support-list_support.elphel.com
_______________________________________________
Support-list mailing list
Support-list@support.elphel.com
http://support.elphel.com/mailman/listinfo/support-list_support.elphel.com
