Updated version. seems i was a bit too fast last time ;-)
Thx for your help. My node is now up and running :-D
May I suggest adding something like the following lines to the
installation instructions for headless systems:
#the old instructions
wget
http://downloads.freenetproject.org/alpha/installer/freenet07.tar.gz
cat freenet07.tar.gz | gzip -d | tar xv
cd freenet
./run.sh start
#followed by
If you want to access the web-interface of the headless system from a
remote computer do:
./run.sh stop
Now modify freenet.ini:
nano freenet.ini //alternative: vi freenet.ini
Add the remote system's IP address to fproxy.bindTo:
e.g. fproxy.bindTo=127.0.0.1,192.168.1.2,0:0:0:0:0:0:0:1
Add the local system's IP address to fproxy.allowedHostsFullAccess
e.g.
fproxy.allowedHostsFullAccess=127.0.0.1,192.168.1.45.0,0:0:0:0:0:0:0:1
or the whole subnet like this:
e.g.
fproxy.allowedHostsFullAccess=127.0.0.1,192.168.1.0/255.255.255.0,0:0:0:0:0:0:0:1
Finally start the node again
./run.sh start
What do you think?
Cheers
Max
Matthew Toseland schrieb:
> On Tuesday 18 March 2008 09:48, Max Giesbert wrote:
>> hi,
>>
>> i just installed freenet on a headless system. my problem now is that i
>> can't connect to the web-interface on port 8888 from my remote system. i
>> already tried fiddling with freenet.ini but no success.
>>
>> what options do i have to set?
>
> Either access the node locally, or forward the port (e.g. using ssh). Then:
> - Go to the config page.
> - Enable advanced mode.
> - Go to the fproxy section.
> - Set the ip address to bind to (e.g. 127.0.0.1,192.168.1.1)
> - Set the allowed hosts ("Hostnames or IP addresses that are allowed to
> connect to fproxy").
> - Set the hosts allowed full access ("Hosts having full access to FProxy").
> - Go back to the top of the page, click on FCP, and do the same for FCP.
>
> Obviously you will need to know the PC's IP address and hostmask. Your
> operating system should tell you this.
>> thx
>>
>> max
--
Max Giesbert - exactt technology
Schießstättstr. 16 T: +49 17 75 07 53 44
D-80339 München F: +49 89 1 22 21 97 02
--
Max Giesbert - exactt technology
Schießstättstr. 16 T: +49 17 75 07 53 44
D-80339 München F: +49 89 1 22 21 97 02
_______________________________________________
Support mailing list
[email protected]
http://news.gmane.org/gmane.network.freenet.support
Unsubscribe at http://emu.freenetproject.org/cgi-bin/mailman/listinfo/support
Or mailto:[EMAIL PROTECTED]
