> lsmod displays just one module - ipv6 sounds familiar. when was the last time you updated your kernel/modules?
> ifconfig does not show any interface > the only '*ether*' module under /lib/modules is > /lib/modules/2.6.24/kernel/drivers/net/usb/cdc_ether.ko i am pretty sure there should be g_ether as well -- and since it went awol it's probably the cause of your worries. > however, if I boot the Neo fully from the SD-card with Om2008.9, > then lsmod displays the same module (ipv6) and cdc_ether is also > the only '*ether*' module found. > ifconfig displays eth0, lo and usb0. sounds like the modules are built-in, lo is ok (forgot it) but eth0 is wlan. i wonder why it would be enabled by default. anyway, i propose to update your kernel/modules and reboot. since you got another booting installation on your sd card it should be pretty safe. >> as a workaround (i do not know, how the script continues) you might try >> to >> put an & at the end of that line >> ifup -a & >> so that, hopefully, the process backgrounds and the booting continues. > > hmm - and is this a good idea? how would i know? :-) as said before: i don't know the script in question and the distribution either. you could even remove the link, causing the script to remain unexecuted. _______________________________________________ support mailing list [email protected] https://lists.openmoko.org/mailman/listinfo/support
