Timo Juhani Lindfors wrote: > Stacy Millions <slm309...@millions.ca> writes: >> I will put together a debug cable and see what trace data I can get from >> the modem. Is there any setup that needs to be done to the modem to >> enable the debug output or just plug in cable and go? > > You need to run "gpio J6=0".
Perfect, thanks. I built the debug cable, and ran my test again and captured the debug output from the modem. The sequence of events are as follows - power on modem - issue commands - modem resets - power off modem ==================== AT-Command Interpreter ready AT+CGMR +CGMR: "GSM: gsm_ac_gp_fd_pu_em_cph_ds_vc_cal35_ri_36_amd8_ts0-Moko11" OK AT%CSTAT=1;+CMEE=2;+CREG=2 OK AT+CFUN=1 %CSTAT: PHB, 0 %CSTAT: PHB, 0 %CSTAT: PHB, 0 %CSTAT: PHB, 0 OK AT+COPS=0,0 OK +CREG: 2 +CREG: 5,"2710","C60E" AT-Command Interpreter ready ==================== the debug log is available here: http://www.millions.ca/~stacy/neoFreeRunner/gsm-debug-log-000 -stacy _______________________________________________ support mailing list support@lists.openmoko.org https://lists.openmoko.org/mailman/listinfo/support
