Same on 0.74.8... > Just tested again with 0.74.6: > > If I disable for example the last rule on WAN interface in the > GUI, the error appears. After enabeling the rule again, > the error stays.... > > Scott Ullrich schrieb: > >>I havent tested a Embedded image (remember its second rate citizen in >>pfSense). The PC version works fine. >> >>Scott >> >> >>On 8/10/05, alan walters <[EMAIL PROTECTED]> wrote: >> >> >>>FYI >>> >>>This seems to still be an issue on 0.74.6 at least on a wrap board. >>>I don't notice the error on a standard update on a PC. >>> >>> >>> >>>-----Original Message----- >>>From: Scott Ullrich [mailto:[EMAIL PROTECTED] >>>Sent: 10 August 2005 15:03 >>>To: Randy B >>>Cc: M. Kohn; [email protected] >>>Subject: Re: [pfSense-discussion] Security problem while loading rules? >>> >>>This should not be a problem any longer in the latest version. I >>>would suggest upgrading. >>> >>>Scott >>> >>> >>>On 8/10/05, Randy B <[EMAIL PROTECTED]> wrote: >>> >>> >>>>M. Kohn wrote: >>>> >>>> >>>>>Hi, >>>>> >>>>>I just updated to 0.74.6 and got a problem while loading >>>>>the rules: (Don't know if the problem was there before...) >>>>> >>>>>----- >>>>>Aug 10 09:36:07 192.xxx.xxx.xxx php: There were error(s) >>>>>loading the rules: [...] syntax error pfctl: Syntax error >>>>>in config file: pf rules not loaded - The line in question >>>>>reads [175]: pass quick on dc1 proto esp from 212.xxx.xxx.xxx >>>>>to keep state label "IPSEC: esp proto" >>>>>----- >>>>> >>>> >>>>I had this problem horribly on 0.74.4 too - ended up having to comment >>>>out the entire section of /etc/inc/filter.inc that dealt with IPsec >>>>before the filters would correctly set up and allow me out of my >>>>network. That really sucked. >>>> >>>>In the GUI, it seems like there's a partial IPsec tunnel defined - the >>>>entire line is empty except for 'WAN' in the 'Remote Interface GW'. >>>>When I tried to edit it, I just got a new tunnel. Ergh. >>>> >>>>RB
--------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]
