try installing a version around 0.67 to 0.69... you could try upgrading afterwards, but if you don't need the new features wait for some more bug fixes...
On 16/08/05, alan walters <[EMAIL PROTECTED]> wrote:
I have had this issue lots on two or three boxes since 0.48
I just work around it. Dell 2600, and a custom via chipset board as well
It seems that when you reinstall from cd and upgrade again normally it
does not happen.
I know it sounds stupid but hey I've tried kicking the computers but
that does not seem to work either.
0.64.8 seems very stable at the moment. I would not go anywhere else on
funny hardware.
-----Original Message-----
From: Albert Miles Enabe [mailto:[EMAIL PROTECTED]]
Sent: 16 August 2005 04:54
To: [email protected]
Subject: [pfSense Support] Pfsense unable to boot from hard drive
Hi!
After a few days of continuous operation, my pfsense
box was unable to reboot displaying these last lines
on screen:
Can't work out which disk we are booting from.
Guessed BIOS device 0xffffffff not found by probes,
defaulting to disk0:
The system just hangs after these messages.
I am using the installer from 0.68.12 iso and upgraded
to 0.76.2.
I ran into this problem twice already.
Thank you for some enlightenment on this matter.
Miles
____________________________________________________
Start your day with Yahoo! - make it your home page
http://www.yahoo.com/r/hs
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
