Sorry I don't understand exactly... my CONFIG as follows: OPT1 : 192.168.10.0 /24 (SYNC)Crossover as per tutorial. WAN: PPPoE with DHCP from ISP separate user accounts (2 different IPs on WAN ) LAN: 172.16.24.0/28
So the OPT1 has static IPs when CARP starts. Does WAN (PPPoE) also have to be UP when CARP wants to start? Tx Ivan. -----Original Message----- From: Scott Ullrich [mailto:[EMAIL PROTECTED] Sent: 12 September 2005 05:43 PM To: [email protected] Subject: Re: [pfSense Support] Carp Weirdness - Always reboots to INIT On 9/12/05, Frimmel, Ivan (ISS South Africa) <[EMAIL PROTECTED]> wrote: > 1) kill power on both routers .. 1 is setup with lower advert. Freq than > other. Power them up together. BOTH go into INIT mode always and the virtual > gateway doesn't get created. .Only way to fix this is to disable carp on > Master then enable .. it becomes master , disable carp on slave, it becomes > slave. Carp is up! Any ideas why they don't automagically figure these > things out ? first node up should always be master? I do not show this behavior here. Are you perhaps using PPPoE on the WAN? A ip must be bound to the interface on the same subnet as the CARP ip's. > 2) I only have 2 servers but everytime I reboot one to test it another carp > id gets created in the list ? This has been covered in the list. Each time machines boot they create a random creator id. This is how pfsync works. > 3) dhcp rules and others are replicating across LB rules are not ? I'll look into it. Scott --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED] --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]
