Ok, so I spent sometime on this, this morning. One of the problems I had yesterday during update_file.sh (on 085.4).. it somehow broke OPT1(sync) and kept making it disabled. So carp would never come up, once I got this sorted by going to 085.6 I could go forward.
So .. 1) I brought router2 back up and did all upgrades and reconfigured CARP; 2) CARP still behaves badly 3) Did another update_file.sh after 085.6, CARP haves badly. It may go master/backup first time, but when doing disable/enable it stays init on BOTH routers. I dropped to a shell .. and simply did a "ifconfig carp0 up" on both. CARP comes up in the appropriate mode(master/backup) and virtual IPs work again as expected. i.e. this fixes the issue. Disable/enable button breaks it again. i.e. a working server as Master will go back to init after hitting enable/disable. Hope this helps? Ivan. -----Original Message----- From: Holger Bauer [mailto:[EMAIL PROTECTED] Sent: Wednesday, September 28, 2005 1:49 AM To: [email protected] Subject: AW: [pfSense Support] 050.2 CARP won't go Master or Backup ok, I have experienced some strange problems bringing up CARP-Interfaces here as well (quite reproducable but also a bit sporadic). Scott did several changes and he finally came up with something that now is running on my systems without any problems any more (my systems are also syncing via a crossover-cable, no switch in between). Ivan, if you can please crosslink your systems again and do a "update_file.sh /etc/inc/interfaces.inc" on both system before testing again. To have a switch between two machines is needed if you have more than 2 machines in the cluster but with only two machines it's an additional "point of failure" if the switch dies or only has powerfailure. Syncing should work with crosslink-cables too. So if you can give it a try and report back we would appreciate it. Thank you in advance, Holger -----Ursprüngliche Nachricht----- Von: Bill Marquette [mailto:[EMAIL PROTECTED] Gesendet: Dienstag, 27. September 2005 20:20 An: [email protected] Betreff: Re: [pfSense Support] 050.2 CARP won't go Master or Backup On 9/27/05, Frimmel, Ivan (ISS South Africa) <[EMAIL PROTECTED]> wrote: > HI > > PPPoe is on WAN .. CARP is on LAN with carp sync on OPT1. > > OK so you guys are going to laugh at me. I do feel stupid. As a fault finding > procedure and just to get connectivity back I halted router2, which is UTP > crossed over connected to router 1 on OPT1. So OPT1 (carp sync) is down. (no > link since you need both nic up to have link). CARP will NOT come up without > link on OPT1. My suggestion in terms of best practice is to have a switch on > OPT(sync) when using CARP. It has wasted a lot of my time and it IS my fault > cause I was cheap just using cross over cable. > Tx all .. Hrm...I'll have to test this out at home :-/ At work everything is always plugged into a switch (the machines are miles apart), but at home I'm using a crossover cable for the dedicated sync network. But I didn't think that CARP would stay down forever if the sync interface was down :-/ --Bill --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED] ____________ Virus checked by G DATA AntiVirusKit --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED] --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]
