So what irqs are the 3com and Intel on? -----Original Message----- From: J B [mailto:[EMAIL PROTECTED] Sent: Thursday, September 29, 2005 2:53 PM To: support@pfsense.com Subject: Re: [pfSense Support] NIC issues
The issue is the Intel Pro - not the 3C509 (I have to use this until the QFE card is supported - because I only have 3 pci slots, and need 4 interfaces) The 3C509 is an ISA card - and works just fine JB On Thu, September 29, 2005 3:49 pm, Chris Buechler wrote: > Fleming, John (ZeroChaos) wrote: > > >> 3c509 or 3c905? >> >> >> The 509 is an ISA card which means you need to run the 3com util >> 3c5x9cfg (I think that's what its called) to make sure you don't have >> any irq/io conflicts. >> >> >> > > might have jumpers on the card in lieu of that, a few of them did. Might > also have to muck with some of your resource settings in your BIOS. > > Honestly, unless you have a lot of hair you wouldn't mind losing, I > would suggest trashing ISA cards and getting some PCI NIC's. :) They can > be had for ~$5 USD a pop on ebay. I think the start of the gray hair I'm > getting at 25 was caused by using multiple ISA NIC's on Linux and BSD > firewalls several years ago. ;) > > --------------------------------------------------------------------- > To unsubscribe, e-mail: [EMAIL PROTECTED] > For additional commands, e-mail: [EMAIL PROTECTED] > > > --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED] --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]
