Comes back with nothing. With -v I get this:
# camcontrol devlist -v
scbus-1 on xpt0 bus 0:
< > at scbus-1 target -1 lun -1 (xpt0)
I see the the SATA controller being detected in the boot messages, so I
don't think it is being picked up as SCSI:
atapci1: <Intel ICH7 SATA150 controller> port
0xac98-0xac9f,0xac90-0xac93,0xac80-0xac87,0xac78-0xac7b,0xac60-0xac6f
mem 0xfeb00000-0xfeb003ff irq 20 at device 31.2 on pci0
ata2: <ATA channel 0> on atapci1
ata3: <ATA channel 1> on atapci1
ata4: <ATA channel 2> on atapci1
ata5: <ATA channel 3> on atapci1
Lynn
Chris Buechler wrote:
Lynn A. Roth wrote:
Some more info:
when I run atacontrol info, it appears that the disk is not attached.
what does 'camcontrol devlist' show? As a couple others have pointed
out, this drive might show up as "SCSI".
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
