This is most likely a newbie issue, but here goes.. This is actually a two
part question/issue!
1. For the past week I 've been trying to install a fresh copy of Pfsense
onto my wrap board. I'm able to install and boot .88 just fine. I
attempted to overwrite the image on on 512MB CF card with .90 and first gave
the error messages (didn't save them) and ended on Boot prompt command. I
attempted to install again after downloading a fresh copy off of the mirrors
and then it would get to this, sit there for a while and then reboot:
WRAP.1E v1.09
Wisp-Router.com
Your Full Time Professionals
640 KB Base Memory
130048 KB Extended Memory
01F0 Master 848A SAMSUNG CF/ATA
Phys C/H/S 999/16/63 Log C/H/S 499/32/63
-
So then I took a little break and waited for .92 to come out and now I get
this and it just hangs there
WRAP.1E v1.09
Wisp-Router.com
Your Full Time Professionals
640 KB Base Memory
130048 KB Extended Memory
01F0 Master 848A SAMSUNG CF/ATA
Phys C/H/S 999/16/63 Log C/H/S 499/32/63
Copyright (c) 1992-2005 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
The Regents of the University of California. All rights reserved.
FreeBSD 6.0-RELEASE #0: Fri Nov 4 02:53:05 UTC 2005
[EMAIL PROTECTED]:/usr/obj/usr/src/sys/pfSense_wrap.6
Fatal trap 1: privileged instruction fault while in kernel mode
instruction pointer = 0x20:0xc086588c
stack pointer = 0x28:0xc0c20d20
frame pointer = 0x28:0xc0c20d68
code segment = base 0x0, limit 0xfffff, type 0x1b
= DPL 0, pres 1, def32 1, gran 1
processor eflags = interrupt enabled, resume, IOPL = 0
current process = 0 ()
trap number = 1
panic: privileged instruction fault
Uptime: 1s
#2 question and the reason for the upgrade. I've been having DHCP issues
with pfsense. I've tried m0n0wall and don't seem to have any issues. I
really need to use pfsense for 2 reasons. First the intferface is great and
two, I have an Atheros chipset on wirless card. Once I get this back on up
I'll pay more attention to the log files to see what my problem is... As
I've tried different PCs throughout this process.
Any help would be appreciated!!
\
Thanks,
Barry
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
