I have reloaded the machine using the 02-19-06 iso and then upgraded it to 02-21-06. I restored my config file. I then ran the traffic shaper wizard. I changed the allocated bandwidth to 384 for VOIP to try to fix the previous error. It never finished loading the queues page. It basically sits there "hung". I eventually clicked out into something else. I reset the states table. I tried viewing the queues again but same result, The first queue shows but basically hangs waiting on rest to appear. I have tried rebooting also but no luck. I just ditched the config file. Entering everything again manually. I reran the wizard and I was able to see the queues page. After the changes made by the wizard, VOIP sucks. The queue shows 32 kbit/s with no load at all on the connection. It also shows a lot of drops. I turned off the traffic shaper and the line is as clear as a bell. This was tried using 384 and 512 for upload reserved for VOIP. As another test, I reran the wizard without VOIP enabled. This had poor audio too. I reran the wizard again. This time I enabled the VOIP option for Vonage without alias or IP using 384Kbits/s reserved. I am getting the message about more than %80 of bandwidth again. I have specified 768up and 6000down for the WAN in the wizard. 384 is about half that, not more than %80. I am turning the traffic shaper off and going home for now. Let me know if you have anything you want me to try or if you would like logs etc.
Robert
