Yeah...just do the opposite of what you did to set it up :) go into the carp settings, select all the sync options, point it at the newly rebuild box, hit save...it'll sync across - uncheck all the sync options so you can go back to being the slave box. CARP should still be master at this point. Go to the real master, change the carp priorities back to 0 on all the interfaces, then go back to settings, check all the sync options. take a breath...and you should be done ;)
--Bill On 4/4/06, Derrick MacPherson <[EMAIL PROTECTED]> wrote: > Can I do this, move the slave to a CARP master? > > On Tue, 2006-04-04 at 11:37 -0700, Derrick MacPherson wrote: > > # /etc/rc.firmware pfSenseupgrade /tmp/pfSense-Full-Update- > > RELENG_1_SNAPSHOT_04-03-2006.tgz > > tar: Error opening archive: Failed to open '-C': No such file or > > directory > > Shutdown NOW! > > shutdown: [pid 12380] > > > > > > The system does now not see the hdd, I'll grab the iso and try a fresh > > install, but now that my CARP slave is master, should I make it the > > permanent master so the configuration will be copied over? > > > > > > --------------------------------------------------------------------- > > To unsubscribe, e-mail: [EMAIL PROTECTED] > > For additional commands, e-mail: [EMAIL PROTECTED] > > > > > > > --------------------------------------------------------------------- > To unsubscribe, e-mail: [EMAIL PROTECTED] > For additional commands, e-mail: [EMAIL PROTECTED] > > --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]
