Hi Scott, Just a brief note, I reread what I had written to Bill earlier today, it did read as though the screen dumps were from a previous Beta.
But they are from BETA3 and the Original Screen Dumps that you asked me to upload also were from the Beta3 install as was the ones that I attached to reassure Bill that they were from BETA3 including the system page clearly showing BETA3 plus update in the image. Anyway has been working all afternoon since I updated and I changed the Gateway Rule on WAN from Balancer to WAN GW and OPT1 from Balancer to OPT1 GW. I have not had any more errors at this stage. But I have not rebooted either. So I have not looked for the Bad Load Balance Monitor IP Address Error either. Hopefully it was just a Loop Error message that I had caused. Kindest Regards, Craig Roy Horizon IT Consultants -----Original Message----- From: Scott Ullrich [mailto:[EMAIL PROTECTED] Sent: Wednesday, 19 April 2006 11:36 PM To: [email protected] Subject: Re: [pfSense Support] pfSense Beta3 available Screen Dump Please redo them on beta3. On 4/19/06, Craig Roy <[EMAIL PROTECTED]> wrote: > Hi Bill, same ISO as before Beta 3 as you can see in the screen dumps, and > load balance pool. > > I can redo the Load Balance Pool, but I don't know that it will help, as I > do not import a previous config file as I have had problem each time I have > imported, so I have created new every time since about version .84. > > Kindest Regards, > > Craig Roy > Horizon IT Consultants > [EMAIL PROTECTED] > > AUSTRALIAN RESELLER > FOR > > > -----Original Message----- > From: Bill Marquette [mailto:[EMAIL PROTECTED] > Sent: Wednesday, 19 April 2006 3:07 PM > To: [email protected] > Subject: Re: [pfSense Support] pfSense Beta3 available > > Craig, based on your screenshots in the forum, you weren't running > Beta3 when you took them. I suspect your issue is related to bugs > pre-beta3 in the load balance code. Can you delete your pools and > recreate them? Thanks > > --Bill > > On 4/18/06, Craig Roy <[EMAIL PROTECTED]> wrote: > > Hi Bill, > > > > Yes it is during boot, Network for WAN and OPT are up then they are pulled > > down during Hardware load, then after that Bad Monitor IP Error MSG, then > > loads the LAN, WAN, OPT and firewall rules etc. > > > > There is no record of it in the System Log, and it does not seem to be a > > problem. Don't mind me, I'm a bit of a perfectionist. If I supply a > PFSense > > box to customers then if they watch this they may start trying to fix > things > > but make things worse. > > > > Is it possible to boot PFSense step by step asking to confirm so that I > can > > get the exact point it occurs, if need be? > > > > Kindest Regards, > > > > Craig Roy > > Horizon IT Consultants > > [EMAIL PROTECTED] > > > > AUSTRALIAN RESELLER > > FOR > > > > > > -----Original Message----- > > From: Bill Marquette [mailto:[EMAIL PROTECTED] > > Sent: Wednesday, 19 April 2006 1:53 PM > > To: [email protected] > > Subject: Re: [pfSense Support] pfSense Beta3 available > > > > Can you clarify the "Monitor IP is Bad IP address" error? I don't > > know where you're seeing that (other than during boot). > > > > --Bill > > > > --------------------------------------------------------------------- > > To unsubscribe, e-mail: [EMAIL PROTECTED] > > For additional commands, e-mail: [EMAIL PROTECTED] > > > > -- > > No virus found in this incoming message. > > Checked by AVG Anti-Virus. > > Version: 7.1.384 / Virus Database: 268.4.4/318 - Release Date: 18/04/2006 > > > > > > -- > > No virus found in this outgoing message. > > Checked by AVG Anti-Virus. > > Version: 7.1.384 / Virus Database: 268.4.4/318 - Release Date: 18/04/2006 > > > > > > > > --------------------------------------------------------------------- > > To unsubscribe, e-mail: [EMAIL PROTECTED] > > For additional commands, e-mail: [EMAIL PROTECTED] > > > > > > --------------------------------------------------------------------- > To unsubscribe, e-mail: [EMAIL PROTECTED] > For additional commands, e-mail: [EMAIL PROTECTED] > > -- > No virus found in this incoming message. > Checked by AVG Anti-Virus. > Version: 7.1.384 / Virus Database: 268.4.4/318 - Release Date: 18/04/2006 > > > -- > No virus found in this outgoing message. > Checked by AVG Anti-Virus. > Version: 7.1.384 / Virus Database: 268.4.4/318 - Release Date: 18/04/2006 > > > > > --------------------------------------------------------------------- > To unsubscribe, e-mail: [EMAIL PROTECTED] > For additional commands, e-mail: [EMAIL PROTECTED] > > > --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED] -- No virus found in this incoming message. Checked by AVG Anti-Virus. Version: 7.1.384 / Virus Database: 268.4.4/318 - Release Date: 18/04/2006 -- No virus found in this outgoing message. Checked by AVG Anti-Virus. Version: 7.1.384 / Virus Database: 268.4.4/318 - Release Date: 18/04/2006
<<attachment: SystemOverviewBETA3.jpg>>
--------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]
