you typically would put all ports that are connected directly to a computer or other end user device as an Untagged port. You then need to program your ports that connect to your router and any other switches as Tagged ports. vlan 1 is typically used for management of the network devices and really should not be occupied by end users. I hope this helps,
>> Ryan
-----Original Message-----
From: Bill Marquette [mailto:[EMAIL PROTECTED]]
Sent: Wednesday, May 17, 2006 3:33 PM
To: [email protected]
Subject: Re: [pfSense Support] VLAN setup
On 5/17/06, Ispánovits Imre <[EMAIL PROTECTED]> wrote:
> > True, seconded :) Using dedicated (untagged) vlans for each port in a
> > trunk configuration is a good idea too if your switch supports this.
> >
>
> Trunked vlans? How this looks like?
Again, I think my terminology is getting the better of me.
Lets say port 5 is in vlan 5, but you want it to be a trunk port, not
an access port, you still keep it in vlan 5, but you put vlans 6-10 in
your trunk statement. The native vlan for the port is 5, the tagged
vlans are 6-10. I can't speak to any switches other than Cisco and
even then it's not my job to configure them, I know enough to make it
work on the firewall side.
--Bill
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
