Just to add to this, I just installed PFSense on 2 PE 2850's each with 6 10/100/1000 Interfaces 2GB RAM and 2X250GB Sata Harddrives using Dell's Hardware raid. Using RC1 all is well.
Regards, Scott There are 10 types of people in this world, those who can read binary, and those who cannot. -----Original Message----- From: Vivek Khera [mailto:[EMAIL PROTECTED] Sent: Tuesday, June 27, 2006 9:12 AM To: [email protected] Subject: Re: [pfSense Support] PFSense + Poweredge On Jun 27, 2006, at 5:22 AM, Lee Hetherington wrote: > Im tempted to buy 2x Poweredge 850's with SATA, are their any known > issues installing onto this, im not sure if SATA on these is > supported under FreeBSD... so driving 200 miles is cheaper for you than buying a $150 UPS?!?!? man, you must be underpaid. anyhow, to answer your question, I run Pfsense on a PE SC 400 with a Dell SATA RAID card (which is basically adaptec) with no problems. I've never had problems with FreeBSD not recognizing devices on a Dell box. You should be safe. I know for sure FreeBSD 6.1 recognizes the SATA RAID on a PE800. DISCLAIMER: This e-mail is only intended for the person(s) to whom it is addressed and may contain confidential information. If you have received this e-mail in error, please notify us immediately by reply e-mail and then delete this message from your system. Please do not copy it or use it for any purposes, or disclose its contents to any other person without the consent of the sender. Unless expressly stated herein to the contrary, only agreements in writing, signed by an authorized officer of the Company, may be enforced against it. --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]
