I've tried to install pfSense in my machine (using the CD install) and it seemed to work fine. But, when I rebooted to run from the HD, all that appeared was a 2 line message saying: F1 load system F2 load system
I didn't write down the exact message, so the one above is most likely not the exact one. But pressing anything but F1 did nothing at all. And pressing F1 made the system start loading only to stop 2 seconds later saying it couldn't find the kernel and stoppiong at the loader prompt. An ls command at this prompt gave me a no root system message. At the installation, I created a 20GB partition for pfSense. The hardware I am using is the following: CPU Celeron 2.8GHz (model 755, if I'm not mistaken) Mem 1GB DDR (64MB allocated to video) HD SAMSUNG SP0802N (80 GB) MB Intel D101GCC Video Integrated ATI Radeon X300 based graphics Lan1 integrated Realtek* 8101L Lan2 Realtek 8139 board Any ideas what I may have done wrong? Thank you, Roberto -- ------------------------------------------------------------------- | Marcos Roberto Greiner | | | | Os otimistas acham que estamos no melhor dos mundos | | Os pessimistas tem medo de que isto seja verdade | | Murphy | ------------------------------------------------------------------- | [EMAIL PROTECTED] | ------------------------------------------------------------------- --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]
