Thanks, I will plan this for end of day then. I have a hdd install so I should be ok.
Thanks again. -- Heath Henderson [EMAIL PROTECTED] 1800 288 7750 -- > From: Holger Bauer <[EMAIL PROTECTED]> > Reply-To: <support@pfsense.com> > Date: Tue, 19 Sep 2006 16:59:30 +0200 > To: <support@pfsense.com> > Conversation: [pfSense Support] Load balancer problem > Subject: RE: [pfSense Support] Load balancer problem > > If you run off a hdd full installation upload the full update file at > system>firmware. It will apply the update and reboot after that. You won't > lose your configuration, just a downtime for the reboot. > > If you run from a cf-card and used the embedded image to start with you have > to reflash the card. The version you are running doesn't support updates. > Updates for embedded builds was introduced some versions ago. The new version > however will now be upgradable. Please note that the new image has a size of > 128 mb so you need at least a 128 mb cf-card. This was needed to support > updates for these platforms. If you run this kind of install the future > upgradeprocess will be the same like for the full install but you have to > upload the mini update file. > > Holger > >> -----Original Message----- >> From: Heath Henderson [mailto:[EMAIL PROTECTED] >> Sent: Tuesday, September 19, 2006 3:44 PM >> To: support@pfsense.com >> Subject: Re: [pfSense Support] Load balancer problem >> >> >> This is probably a question which doesn't require an answer, >> but I am a >> little leary about updating to the >> http://www.pfsense.com/~sullrich/1.0-SNAPSHOT-09-18-06/ >> >> I was curious of how to go about the udpate. I see two files >> which look >> like they might be the update files. One is >> >> Pfsense.img and the other is fullupdate. >> >> Please advise. I haven't done any updates yet. We have RC2 >> built Aug1 of >> 2006. No updates have yet been applied. >> >> Thanks >> >> >> -- >> Heath Henderson >> -- >> >> >>> From: Scott Ullrich <[EMAIL PROTECTED]> >>> Reply-To: <support@pfsense.com> >>> Date: Tue, 19 Sep 2006 01:38:10 -0400 >>> To: <support@pfsense.com> >>> Subject: Re: [pfSense Support] Load balancer problem >>> >>> http://www.pfsense.com/~sullrich/1.0-SNAPSHOT-09-18-06/ >> >> >> >> --------------------------------------------------------------------- >> To unsubscribe, e-mail: [EMAIL PROTECTED] >> For additional commands, e-mail: [EMAIL PROTECTED] >> >> > > --------------------------------------------------------------------- > To unsubscribe, e-mail: [EMAIL PROTECTED] > For additional commands, e-mail: [EMAIL PROTECTED] > --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]
