Not quite sure what you are asking... but if I got it right: Setup everything like the DUAL WAN Manual shows Then set everything as the default gateway in your rules except for the IP you want to go out the cable... set that to the cable IP -Tim
-----Original Message----- From: Jaye Mathisen [mailto:[EMAIL PROTECTED] Sent: Friday, January 19, 2007 12:47 AM To: [email protected] Subject: [pfSense Support] Dual WAN, but only 1 default route... I have a DSL connection wiht 32 static IP's, and a cable connection. I have one very specific use for the cable connection and everythign else goes over the DSL. The Cable uses DHCP to assign IP's, and static is not an option for them. My office subnet is NAT'd behind one of the 32 static IP's. I want to continue NAT'ing 99% of the traffic out that interface, and out the cable interface, for the 1 connection to the 1 resource, I want it to be NAT'd, but use the cable for outbound traffic. The catch is, I don't want the cable DHCP info to over-write the default route info that I have configured... Can I do this? Or am I perhaps not asking the question clearly? Probably the latter. --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED] --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]
