On 3/28/07, Robert Goley <[EMAIL PROTECTED]> wrote:
I have 1 existing DSL connection and 2 existing Cable connections. I am
adding 2 more Cable connections as part of a phase-in/phase-out scenario.
The current setup works great. It is using policy based routing on pfsense
1.0.1. I can not seem to get the additional interfaces to work. I have
tested with my laptop and know the the ISP routers are setup and working
correctly as bridges. On my laptop, all I have to do is enter the correct
static IP information to use the internet. The ISP threw me off a little
setting the router IP as the highest number in the assigned IP range. All
other ISPs have used the lowest. I am not sure how to enter the static IP
info for the OPTx interfaces because of this. I have been assigned
x.x.x.49-x.x.x.53 with the default gateway being x.x.x.54. It is a /29
netblock with netmask 255.255.255.248. Would I enter this as x.x.x.49/29,
x.x.x.53/29, or x.x.x.54/29? I am not getting any traffic thru the interface
when I have tried using these. I setup a port forward for SSH to a test
machine on the network. It does not go thru. Is there a default traffic
rule I have missed adding somewhere? Any information you can provide would
be appreciated.
Robert
Use the same settings that you got working on your laptop?
Can you ping the gateway in question from the pfsense firewall?
sai
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
