Yeah, I read that. But I don't want load balancing or failover.
Logging in via shell shows the routing is set right, in that the
default route is still WAN.
# netstat -rn
Routing tables
Internet:
Destination Gateway Flags Refs Use Netif Expire
default 70.58.179.174 UGS 0 837 sis0
I created an OPT1 interface, set it to DHCP. Went to firewall rules
and added a rule that sent proto:any, source:*, Port*, dest 4.2.2.2,
port *, Gateway OPT1.
# User-defined rules follow
pass in quick on $lan from 192.168.0.0/24 to any keep state label "USER_RULE: D
efault LAN -> any"
pass in log quick on $lan route-to ( sis2 192.168.100.1 ) from any to { 4.2.2.
2 } keep state label "USER_RULE"
But all traffic is now going out the OPT1 interface, instead of just
traffic to 4.2.2.2
Tracing route to pfsense.org [69.64.6.13]
over a maximum of 30 hops:
1 <1 ms <1 ms <1 ms 192.168.0.1
2 * * * Request timed out.
3 38 ms 38 ms 39 ms 67.42.192.195
4 36 ms 36 ms 35 ms 67.42.192.125
5 35 ms 36 ms 35 ms 205.171.150.33
What's weirder is that the ISP on OPT1 is allowing the
traffic packets with my WAN interface IP to pass through
it. It doesn't appear to be nat'd to the OPT1 interface
IP either...
On Thu, Apr 05, 2007 at 11:38:27PM +0200, Holger Bauer wrote:
> http://doc.pfsense.org/index.php/Multi-Wan/Load-Balancing
>
>
> Holger
>
> -----Original Message-----
> From: Fuchs, Martin [mailto:[EMAIL PROTECTED]
> Sent: Thursday, April 05, 2007 11:13 PM
> To: [email protected]
> Subject: AW: [pfSense Support] OK, I think this is simple...
>
> I don't have thos config, but i could imagine it works with the gateway
> option (select a gateway different than default) Perhaps it might be
> necessary to define a pool or else fort hat...
>
> Just try a bit :-)
>
> Regards, Martin
>
> -----Urspr?ngliche Nachricht-----
> Von: Jaye Mathisen [mailto:[EMAIL PROTECTED]
> Gesendet: Donnerstag, 5. April 2007 22:53
> An: [email protected]
> Betreff: [pfSense Support] OK, I think this is simple...
>
>
>
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
