Re: [pfSense Support] help to config dmz

Sat, 26 May 2007 05:48:23 -0700

Add a new interface? But i can have the public ips from my PPPoE to another interface?
I have setup the system like this:

adsl router (but i useit as modem, the pfsense connect with ethernet and make PPPoE connection and the adsl modem it is just a "modem" connected to pfsense with ethernet cable)
| wan
pfsense
| lan                                                   | DMZ

So the pfsense ca nhave the ips only from the PPPoE connection.


Tim Dickson wrote: 
I would add a fourth interface and make it a part of that new subnet.
Then you can bridge that interface to your DMZ.
That will allow pfSense to do the routing.
In your rules just make sure to make the gateway the second wan
interface.
(that's how I have it setup... and it works)
-Tim

PS... I opted for 1:1 rather than bridging.  This gives the servers
public addresses, but also allows me to expand in ways not possible with
bridging.


-----Original Message-----
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED]] On Behalf Of Rob
Terhaar
Sent: Friday, May 25, 2007 9:37 AM
To: [email protected]
Subject: Re: [pfSense Support] help to config dmz

On 5/25/07, Christos Pelekis <[EMAIL PROTECTED]> wrote:
  
Hi,
thanks. But also now i have and one more problem.
The WAN is PPPoE and i want to add in WAN one more subnet with 16 ips.
You know how i can do this?
Regards
    

setup an additional router? :)

---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]



---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
--------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]

Reply via email to